Hey, I’m about to put a foam adhesive gasket on the lid of my Weber kettle (hoping to seal it up a bit). I’ve got it all cleaned up, 3 years of smoke, grime, and gunk all scraped off. Do I want to put the gasket on the outermost ‘vertical’ portion of the lid, where the lid meets the outside surface of the bowl, or on the more ‘horizontal’ surface of the lid, where the lid meets the upper edge of the bowl? I’m guessing where the lid meets the upper edge of the bowl, but thought I’d do a quick double-check with people who have done this before.
Also, should I leave a gap in the gasket, where I can run my temperature probe wires through, or can I just run those anywhere over the gasket?
Thanks in advance!!
Also, should I leave a gap in the gasket, where I can run my temperature probe wires through, or can I just run those anywhere over the gasket?
Thanks in advance!!
Comment