got a Stampede (590?) and the original lid didn’t fit right, got a replacement and the 2nd has the same issue. Using infrared temp gun, one side, with proper fit of lid has temp 20 degrees higher than set, the side with poor fit lid, I rigged aluminum foil to lessen the gap>>> now it’s 50 too low.
Only thing I can figure is the airflow is messed up? Perhaps the lid is supposed be offset? Haven’t talked to Rec Tec yet, but when I notified them of the misfit lid, they sent me a new one.
anyone had a similar experience???
They just sent me a new auger motor, which I have yet to install. This is after installing a new Controller and RTD. I appreciate you asking, and will keep you posted.
Oops, sorry, I realize that your questions may have not been for me, but I also have been having temp issues on my RT 680. You can see above the steps so far. Been going on for a while now.
Customer service had me slow down auger speed, and let it run an hour to recalibrate. It def got better. Since then it seems to have gotten a little out of line again. The exhaust side simply runs a bit hotter
Comment