Grid Iron, ash all over the place

[theman56]

I figured it out myself. I think I posted 1/4 inch but it is a 1/2 inch

[dave_trimble]

I was thinking that looked like a big gap for 1/4". I didn't have spacers like those, so I just put 3 washers on each bolt, which leaves a gap just shy of 1/4". Fired it up to 350, and there was still a little bit of ash flying around, but it might just be the ash that was already deposited getting stirred up. After it cools, I'm going to vacuum it out and see if it's good to go.

[theman56]

Let me know how you make out.