For those of you that have a Gen 2 or 3 Performer, there's a metal table top that is nearly a direct fit to replace the fiberglass top you can't clean...
I just picked up a Gen 2 Performer in BLUE, and am adding an accurate thermometer low to the grate, a grommet for temp probe lines, a gasket, and a new metal prep-area top. The link for one of the suppliers of the top is below. Your Performer may require two new holes drilled, and a nut and bolt for the tip-out charcoal/waste bin - it may not. Regardless, you can have a new top in 15 minutes or less. All the reviews were 5 stars.

I just picked up a Gen 2 Performer in BLUE, and am adding an accurate thermometer low to the grate, a grommet for temp probe lines, a gasket, and a new metal prep-area top. The link for one of the suppliers of the top is below. Your Performer may require two new holes drilled, and a nut and bolt for the tip-out charcoal/waste bin - it may not. Regardless, you can have a new top in 15 minutes or less. All the reviews were 5 stars.









Comment