Has anyone found an aftermarket temperature probe that works with the Pellet Boss Controller? The probes I have with for my Thermoworks devices fit but must run off a different frequency because they read about 50 degrees higher. Thanks in advance to anyone that has already dug into this and knows the answer.
-
Last edited by evollbrecht; January 7, 2018, 07:43 AM. -
Realize this is an old thread, but just got a couple of these and they work fine. As a bonus the cord is a little longer than the Mak provided one.
-
With the age of this post, he's probably referring to the old style probe which was expensive and liked to fail. There were no 3rd party replacements. I upgraded my controller to the k-style one because it will pay for itself with lower priced replacement probes over time
FWIW I had the exact probe you linked and it failed on my within 6 months. I suggest keeping a look out for Thermoworks sales and buying a couple to have on hand in case something goes wrong and it's not sale season
Last edited by ItsAllGoneToTheDogs; January 2, 2021, 08:18 AM.
-
Comment