Recently, I picked up a 3 pack of baby backs at Costco. After putting two in the freezer, I started preparing one for smoking. In preparing ribs, I always start by pulling off the sheath that resides on the bone side of the rib slab. The sheath on this particular slab was too thin to pull off. First, it was hard to get any kind of purchase on the sheath, on any part the slab. When I could manage to get a grip on the sheath, I could never pull much off before it would tear along the surface where it was still attached. What's a poor feller to do about this?
Announcement
Collapse
No announcement yet.
That Darned Sheath
Collapse
X
-
Club Member
- Nov 2015
- 4688
- The Great State of Jefferson
-
24X40 Lone Star Grillz offset smoker
Weber Summit Charcoal Grill w/SnS and DnG (Spartacus)
20X36 Lonestar Grillz pellet pooper
SnS 18" Travel Kettle
SmokeDaddy Pro portable pellet pooper
2 W22's w/SnS, DnG (1 black, 1 copper) (Minions 1 and 2)
20+ y/o many times rebuilt Weber Genesis w/GrillGrates (Gas Passer)
20 x 30 Santa Maria grill (Maria, duh)
Bradley cabinet smoker (Pepper Gomez)
36" Blackstone griddle (The Black Beauty)
Fireboard
Thermoworks Smoke and Thermapen.
Gourmet dinnerware by PJ Enterprises
-
Club Member
- Jul 2016
- 1405
- Bacliff, TX
-
Motovlogging for the freedom of old Hippies...
https://www.youtube.com/c/LonnieMac
Home of Brutus Ten!
http://www.alenuts.com/Alenuts/Alenuts.html
Pits:
Weber Performer Deluxe W/ SNS, Craycort CI grates
WSCGC (Weber Summit Charcoal Grill Center W/ SNS Plus, DNG
Texas Original Pits Offset Smoker
RecTec 590
WSM 18" W/ Upside-down door mod
Camp Chief Flattop, The big one...
Weber Genesis II S-335
Texas Fire Pit
Thermos:
Maveric's Most all of em...
FireBoard W/ Fan Control, GURU Fan
ThermoWorks, most all of em...
Meater
As noted, very likely already removed and what you are looking is a bit of fat layer. Personally, and Moonbeam and I are probably the only two people on earth, but we LOVE the stuff! I leave it on and eat every bite!!
- Likes 3
Comment
-
Club Member
- Nov 2017
- 7086
- Huntsville, Alabama
-
Jim Morris
Cookers- Slow 'N Sear Deluxe Kamado (2021)
- Camp Chef FTG900 Flat Top Grill (2020)
- Weber Genesis II E-410 w/ GrillGrates (2019)
- Weber Performer Deluxe 22.5" w/ GrillGrates & Slow 'N Sear & Drip N Griddle & Vortex & Party Q & Rotisserie (2007)
- Custom Built Offset Smoker (304SS, 22"x34" grate, circa 1985)
- King Kooker 94/90TKD 105K/60K dual burner patio stove
- Lodge L8D03 5 quart dutch oven
- Lodge L10SK3 12" skillet
- Anova
- Thermoworks Smoke w/ Wifi Gateway
- Thermoworks Dot
- Thermoworks Thermapen Classic
- Thermoworks RT600C
- Weber Connect
- Whatever I brewed and have on tap!
Haha first time I picked up baby back ribs at Costco I tried the same thing, and punched myself in the head once I realized the membrane had already been removed by Smithfield or whoever packed the ribs.
The ones I usually get from Sam's Club have the membrane usually, although two weeks ago, a 3 pack from Sam's Club had 1 of 3 with the membrane already removed...
I don't know if they are always like that at Costco, but the ones I've got were. Saves a couple minutes of prep time for sure.
Comment
-
DogFaced PonySoldier - you will notice the difference. Its a tough, unchewable paper like membrane once cooked, almost like a thin layer of plastic. Also, no spices or sauces penetrate that side of the ribs. I should know, considering I cooked ribs without removing this for about half my life, due to sheer ignorance.
-
jfmorris glad you said something, I had the exact same thing happen the last time I picked up a 3 pack from Sam's. Thought I'd lost my mind, couldn't seem to find or get a hold of the membrane on ONE of the three racks!
-
Thanks jfmorris, what you said sounds right, Up until recently, I was buying baby backs at Sam's. Never had a problem finding and removing the membrane.
-
Club Member
- Dec 2015
- 2406
- NE OK - South of Bonesy
-
Traeger BBQ124
Yoder YS480
Chargriller Duo gas/charcoal side-by side
Blackstone 36" griddle
Camp Chef Smoke Vault 24 propane smoker
*current project - 330 gallon offset stickburner in progress*
Personal firearms, home theater, home computing/networking, car audio enthusiast.
I was watching Guy Fieri on Triple D one time, he went to a place where they left them on - I think it was in Las Vegas?? - and he was absolutely blown away. He couldn't believe someone was cooking and serving these in a professional setting and wasn't removing the membrane. The guy assured him they sold thousands of racks like this and that he would love it - and he did! He said he was shocked but he couldn't tell a difference and he absolutely loved them. I think I may give it a try.
Comment
-
Club Member
- Jul 2016
- 3394
- Elizabethtown, KY
-
Current line-up of cookers: Oklahoma Joe's Bronco Pro, Masterbuilt Gravity Series 1050, Blackstone ProSeries 4 Burner 36" griddle, Weber Performer Deluxe and Weber Smokey Joe.
I believe Aaron Franklin leaves them on, and he seems to be doing ok. It ain't my thing, though. I'll remove it or otherwise mutilate it to allow consistent tenderness.
- Likes 1
Comment
-
-
Club Member
- Nov 2017
- 7086
- Huntsville, Alabama
-
Jim Morris
Cookers- Slow 'N Sear Deluxe Kamado (2021)
- Camp Chef FTG900 Flat Top Grill (2020)
- Weber Genesis II E-410 w/ GrillGrates (2019)
- Weber Performer Deluxe 22.5" w/ GrillGrates & Slow 'N Sear & Drip N Griddle & Vortex & Party Q & Rotisserie (2007)
- Custom Built Offset Smoker (304SS, 22"x34" grate, circa 1985)
- King Kooker 94/90TKD 105K/60K dual burner patio stove
- Lodge L8D03 5 quart dutch oven
- Lodge L10SK3 12" skillet
- Anova
- Thermoworks Smoke w/ Wifi Gateway
- Thermoworks Dot
- Thermoworks Thermapen Classic
- Thermoworks RT600C
- Weber Connect
- Whatever I brewed and have on tap!
Announcement
Collapse
No announcement yet.
Comment